REGULATED BIPOLAR HIGH VOLTAGE POWER SUPPLY
1kV to 5kV, 50W to 300W
REGULATED DUAL HIGH VOLTAGE POWER SUPPLY
1kV to 100kV, 50W to 5kW
This series of power supplies can generate two independent outputs of same or opposite polarities in the same power supply both having single control OR independent controls depending on requirement. These are housed in compact 19’’ racks to give a highly regulated output.
Download Datasheet
TECHNICAL SPECIFICATIONS
| PARAMETER | SPECIFICATION | ||||||
|---|---|---|---|---|---|---|---|
| Input Voltage | 230V ±10% AC, 50Hz, single phase for output power ≤2kW 415V ±10% AC, 50Hz, three phase for output power ≥2kW |
||||||
| Output Voltage Range* | 1kV to 100kV DC | ||||||
| Output Power Range* | 50W to 5kW | ||||||
| Number of Outputs | 2 | ||||||
| Polarity* | Positive & negative (Two outputs will be available simultaneously) | ||||||
|
|
||||||
|
|
||||||
| Load Regulation | ≤ 0.1% for 0 to 100% load variation | ||||||
| Stability | < 0.1 to 0.05%/hour after 1 hour warm up | ||||||
| Temperature Coefficient | < 0.1 to 0.05%/ºC | ||||||
| Regulating Mode | Constant voltage – Constant current | ||||||
| Voltage & Current Control # | Voltage & Current Control # Local: By 10-turn potentiometers on the front panel Remote: 0 to 10V DC signals for voltage & current control; OR Control through computer interface |
||||||
| Protections* | Against short-circuit and arc | ||||||
| Remote Controls & Signals through Pluggable Connector / D-Connector (External RS232 Microcontroller Module) # | 10V DC reference 10V DC HV enable signal 0 to 10V DC signal for voltage & current control 0 to 10V DC signal for voltage & current monitoring |
||||||
| Front Panel | Power ON/OFF switch with indication Output ON/OFF switch with indication (2 sets) 3½ digit voltage and current meters (2 sets) 10-turn potentiometer for voltage control Constant voltage – constant current mode indication (2 sets) |
||||||
| Back Panel | Socket for mains input with 250V, 10A 3 conductor power cord of 1.5 meters / Terminal block for 3 phase input Fuse holder with fuse Terminals for output Stud for grounding the unit Remote interface connector # (2 sets) |
||||||
| Topology | High frequency resonant / PWM-controlled switch mode | ||||||
| Switching Device | IGBT | ||||||
| Cabinet | 19” rack, powder coated |
*Optional. To be specified by the user.
#For remote operation RS232 available at an extra cost.